Auxiliary Heater Used on Gasoline and Diesel Vehicles Less Turbodiesel for 1986 Mercedes-Benz 300E

Description: Heater unit.

Description: BRACKET TO HEATER UNIT
Diameter: 70-90mm
Material thickness: 1mm
Width across flats: SW8. COLD-AIR SCOOP TO FENDER, RIGHT
Diameter: 70-90mm
Material thickness: 1mm
Width across flats: SW8. Refrigerant reservoir to wheel well
Diameter: 70-90mm
Material thickness: 1mm
Width across flats: SW8. FUEL FILTER
Diameter: 70-90mm
Material thickness: 1mm
Width across flats: SW8.

Description: Heater unit to wheel arch.

Description: Intake muffler.

Description: (flame detection photocell).

Description: 140mm.

Description: Resistor.

Description: To 129 545 06 28. 1.0 mm2. 2.5. 1.0 mm2.

Description: 16-24mm.

Description: Electric change-over valve.

Description: Electric change-over valve.

Description: Hose to radiator,thermostat,and water pump.

Description: At right side member. Heater unit. At left side member. Bracket to wheel arch panel. Bracket to right wheelhouse. Pipe line to side member.

Description: Exhaust muffler.

Description: Bz6,3x13. Bracket mounting. Control unit to the right of legroom.

Description: Between heater unit and exhaust muffler. At right side member. End piece fastening.

Description: Bracket to battery case. Control unit to battery case.

Description: Fuel-oil pump. 10mm. Fuel hose. From engine return line to tank. Heater unit. Connection to feed pump.

Description: From fuel-oil pump to fuel line.

Description: Fuel-oil pump. Independent heating. Metering pump.

Description: Fuel-oil pump. Fuel pump on cross member.

Description: M5x10.5. At blower;temperature sensor ventilation. Bracket to fire wall. Heat shield mounting. Control unit. Screening plates. Main floor,front right. Return line to partition panel.

Description: Fuel line to floor,right.

Description: Fuel line under main floor. Brake and fuel lines to vehicle floor.

Description: Underbody left. Fuel line to floor,right. To mount fuel lines. In wheelhouse front left. To firewall and longitudinal member. Brake line to cross member.

Description: At motor. 14-16 mm. Left rear brake cable. 14-16 mm. Line to line. 14-16 MM. Oil line connection. 14-16 mm.

Description: From engine feed to piping.

Description: De-aeration valve.

Description: Heater unit outlet to de-aeration and timing valves. Oil drain. At right side member.

Description: From piping to heat exchanger, feed.

Description: From timing valve to return pipe.

Description: From valve to additional heater return line. From heat exchanger to auxiliary heater return line.

Description: From valve to additional heater return line. From heat exchanger to auxiliary heater return line.

Description: From engine to heater.

Description: Door check to front door. Pipe line to unit partition panel. Locking mechanism. Safety hook to engine hood. Line to steering. Additional blower to front central stiffening. Bracket to unit partition panel. Control unit to bracket ke.

Description: From fuel pump to accumulator.

Description: Fuel-oil pump.

Description: M5x10. Bracket mounting.

Description: Brake line to fire wall. Right rear brake line to cross member. Chafe protection. Front right brake line mounting to right longitudinal member. 4,5 x 14,5 x 40. At brake line between hydraulic unit and frame bracket. To fuel line. To spring tower, left. Protection against scoring for pipe line.

Description: Cable to terminal b+. Positive cable to battery.